Installing Marine Carpet is Easier than you Think

What you will need:

Marine Carpet
Marine Grade Adhesive
Tape Measure
Utility or Carpet Knife
Scraper
Mineral Spirits/ Acetone
Small Clamps or Weights
Trowel
Roller or Stiff Broom
Rags

Step 1: Remove Old Carpet

TIP: If you haven’t done so already, remove seats and fixtures. Mark them with where they came from for later.

Remove old carpet and clean off any remaining glue residue using scraper, mineral spirits and sand paper for heavy areas. Clean and dry all areas to be carpeted. This is a good opportunity to inspect deck and areas below for water damage or hidden structural issues.

Step 2: Cut Carpet to Size

TIP: Always allow for extra when you are doing your measurements. The carpet has direction, so the carpet needs to be in the same direction on each cut piece. Include other carpeted areas, like walls and speaker boxes you may want to add later. Better to have too much than not enough. Remove seats and fixtures (mark locations and directions of each piece) for accurate measurements.

Use oversized measurements to rough cut the carpet to approximate size. Lay carpet in place on the boat, using weights or clamps to prevent shifting. Custom cut carpet for an exact fit using a very sharp utility knife or carpet knife. Once fit is right, clamp or weigh carpet down to the left (port) side only. Fold carpet in half lengthwise (bow to stern), revealing the right side of the floor.

TIP: Lay carpet out, unrolled, in the sun for several hours (on a dry day, between 65F-90F). Allowing the carpet to warm softens the backing making it more pliable and easier to handle, position and cut.

Step 3: Apply Adhesive

TIP: Do not start the following steps until you are sure you have 24-48 hours of dry weather with temps between 65F – 90F.

Apply carpet glue with trowel using circular motions moving from front to back. You are looking to apply a thickness equal to a heavy coat of paint. Do not allow glue to puddle or leave any dry areas. For best results, allow glue to get tacky before unfolding carpet onto side with glue, but be careful as it will not come up again, so make sure to lay the carpet straight, with no wrinkles. You may now remove clamps and weight from the left side of the carpet and fold over the side just glued. Repeat glue application process.

Use roller or stiff broom, from the center to all edges, to remove air bubbles and ensure good contact between carpet and glue. Without this step, bubbles or lines may develop or areas of carpet may come up over time. Carpet will start to cure between 3-4 hours, but should be left to dry fully (24hrs) before vacuuming, installing rails and seats or subjecting to foot traffic. Wait 48 hrs before using in water.

Get out there!

Get out there!

Leave a Reply

 

 

 

You can use these HTML tags

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

ciprofloxacin for diverticulitus buspar for childhood aggression treating infant thrush with diflucan flomax treatment for prostaitis low cost diflucan